Pass Exam Questions Efficiently With DEA-41T1 Questions (2022)
DEA-41T1 Questions - Truly Beneficial For Your EMC Exam
NEW QUESTION 24
A server room has two power grids, A and
B. PSU1 on each server is on grid A, and PSU2 is on grid B. Grid B has significantly lower load compared to grid A.
What is the most likely cause of the unbalanced power load?
- A. UPS and PDU are not installed to balance the load
- B. Hot spare feature is enabled in power supply configuration
- C. PSU1 is always the primary power supply
- D. PSU1 is a higher wattage power supply than PSU2
Answer: C
NEW QUESTION 25
Refer to the exhibit.
What is this system referred to?
- A. CRAH
- B. HAC
- C. FANS
- D. HVAC
Answer: D
NEW QUESTION 26
An administrator has been tasked with installing a server with greater than 2TB partition.
Which boot mode would allow this?
- A. UEFI
- B. BIOS
- C. GUID
- D. GRUB
Answer: A
NEW QUESTION 27
A customer needs to access webmailon a laptop. Using a browser, they type in the URL and the page display correctly. What is the correct of stops used to load the webpage?
Answer:
Explanation:
NEW QUESTION 28
Which dual-level RAID configuration is combine to configure RAID 10 on a single array?
- A. RAID 1 and RAAID and strip
- B. RAID 0 and RAID 1. mirrored and strip
- C. RAID 0 and RAID1, strip and mirrored
- D. RAID a and RAID 1, mirroredand parity
Answer: A
NEW QUESTION 29
What is a key characteristic of a Type 2 hypervisor?
- A. Runs on an operating system installed on the host without direct access to the hardware
- B. Runs directly on the with direct access to the hardware
- C. Runs directly on the without direct access to the hardware
- D. Runs on an operating system installedto the host direct access to the hardware
Answer: A
NEW QUESTION 30
A server administrator needs to change the settings of their iDRAC utilizing just the front panel.
Which configuration would allow this?
- A. LED Only
- B. LCD Only
- C. Both LCD and LED
- D. LED with Quick Sync 2
Answer: C
NEW QUESTION 31
Whatis a consideration for a hardware administrator who is physically is physically installing multiple servers into a rack?
- A. Ensure that the server can connect to Windows updates
- B. Avoid unevenly loading the rack and creating a hazard
- C. Observe load requirements specified in document for the switch
- D. Ensure that the associated UPS can also power the top-ofrack switch
Answer: D
NEW QUESTION 32
What should an administrator review, prior to deploying an operating system (OS), to confirm there are no hardware incompatibilities with the desired OS?
- A. iDRAC SEL
- B. LCC Log
- C. HCL
- D. BPA
Answer: A
NEW QUESTION 33
A system administrator wants to view the result of the Best Practices Analyzer (BPA) for their local server.
Which Windows built-in tool can they use to accomplish this?
- A. Resource Monitor
- B. Security Compliance Manager
- C. Activity Monitor
- D. Server Manager_Local Server
Answer: D
NEW QUESTION 34
A system administrator is tasked with troubleshooting a connectivity issue with a CMC module. Connection through a wired Ethernet connection is not possible.
Which alternative connection method should the administrator use?
- A. Serial
- B. NFC
- C. Wireless
- D. SSH
Answer: A
NEW QUESTION 35
Which error control technique is used by ECC memory?
- A. Cryptographic hash functions
- B. Repetition codes
- C. Checksums
- D. Hamming code
Answer: D
Explanation:
Explanation/Reference: https://en.wikipedia.org/wiki/ECC_memory
NEW QUESTION 36
What is an alternative configuration for a 40Gbps Ethernet connection?
- A. 10x 4 Gbps
- B. 1x 25 Gbps
- C. 1x 10 Gbps
- D. 4x 10 Gbps
Answer: D
Explanation:
Explanation/Reference: https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/ esuprt_net_fxd_prt_swtchs/networking-n3100-series_user%27s-guide10_en-us.pdf
NEW QUESTION 37
A system administrator needs to configure their Dell EMC PowerEdge server for PXE boot in UEFI mode.
What is the correct order of steps to accomplish this?
Answer:
Explanation:
NEW QUESTION 38
An MX7000 was purchased with minimal configuration.
What can an administrator add to make the MX7000 management interface fully redundant?
- A. Enterprise license
- B. MX9116n module
- C. CMC module
- D. MX9002m module
Answer: C
NEW QUESTION 39
Refer to the exhibit.
An administrator has a standalone M1000e chassis with only a single CMC module. The CAT6 cable is plugged into the Ethernet port closest to the DB-9 connector. The power indicator light is lit but the administrator is unable to access the CMC module.
What could be the cause of this issue?
- A. CMC module was removed without powering off the chassis
- B. No DB-9 serial cable is plugged in
- C. CAT6 cable into the stacking port
- D. CAT5 cable is required for connection to CMC
Answer: B
Explanation:
Explanation/Reference:
Reference: https://topics-cdn.dell.com/pdf/poweredge-m1000e_owners-manual_en-us.pdf
NEW QUESTION 40
What is the purpose of the DNS role?
- A. transfer computer files between a client and a server
- B. Translate domain names into IP address
- C. Send out emails from a server to a client
- D. Distribute and update dynamic IP address
Answer: B
NEW QUESTION 41
A system administrator is tasks with troubleshooting a connectivity issue with a CMC module. Connection through a wired Ethernet connection is not possible.
Which alternative connection method should the administrator use?
- A. Serial
- B. NFC
- C. Wireless
- D. SSH
Answer: A
NEW QUESTION 42
Based on the exhibit, which device is a Boot Optimized Storage Solution (BOSS) Controller?
A)
B)
C)
D)
- A. Exhibit C
- B. Exhibit D
- C. Exhibit B
- D. Exhibit A
Answer: D
NEW QUESTION 43
What is a backup process?
- A. Using server technologies data from one computer node to another.
- B. Moving data that is no longer actively used to a separate storage device, for long-term retention.
- C. Copying files to a secondary site for preservation in case of equipment failure or other catastrophe.
- D. Capturing historical records used for future reference and is not actively used by the server.
Answer: C
NEW QUESTION 44
A server room has two power grids, A and B. PSU1 on each server is on grid A, and PSU2 is on grid B. Grid B has significantly lower load compared to grid A.
What is the most likely cause of the unbalanced power load?
- A. UPS and PDU are not installed to balance the load
- B. Hot spare feature is enabled in power supply configuration
- C. PSU1 is always the primary power supply
- D. PSU1 is a higher wattage power supply than PSU2
Answer: C
NEW QUESTION 45
......
Conclusion
The Dell DEA-41T1 exam is critical in availing professionals who can be part of the journey of innovation through PowerEdge servers. For notable acquisition of skills, training, and guides offered by the vendor would be the best to use. Beyond skills, utilizing such valuable revision materials will be a vital part of providing backup for exam preparation. Thus, with the experience and comprehension, your opportunity to make a difference in your enterprise will be greatly enhanced. Use the training and revision resources to make yourself ready for the test as well as your professional role and get Dell accredited hassle-free.
Truly Beneficial For Your EMC Exam: https://certkingdom.practicedump.com/DEA-41T1-practice-dumps.html